Hot melting machine for EPS
It is used for crushing all kinds of soft or hard foam plastics to compressed plastic for next pelletizing. It is especially for compressing waste EPS foam products.
Feature:
1. Adopting deafener low in noise.
2. Adopting removable blades which can be separately removed and sharpened after getting blunt.
3. Suitbale for smashing all kinds of soft ,hard and foamed plastics.
4. Easy to operate and high output
Application:
Milon Hot Melted System is used to melt the plastic waste like EPS EPP EPE XPS. The good reduction in volume can be achieved in this manner to save transport and disposal cost.
Compressed block can be reused as high quality granulate by recycling companies and other related manufacturers.
Processing Method:
The operator firstly runs the heating system to pre-heat the screw to reach rated temperature, and then throws plastic waste into hopper of the machine, and then the pre-breaker with two rotating knife shafts will crush it into 10~50mm pieces, which are forced by a screw into the extruder system.
Technical Parameters:
|
Screw diameter |
φ197 mm |
|
Screw distance |
150 mm |
|
Screw speed |
110 r/min |
|
Capacity |
100～120Kg/h |
|
Screen hole diameter |
40mm |
|
Extrusion center height |
326 mm |
|
Motor power |
15KW |
|
Heating power |
3 zones total 10kw |
|
Crusher motor power |
2.2kwx2 |
|
Crusher blades quatity |
Twin screw 11sets+10sets |
|
Crusher rotation speed |
100r/m |
|
Size L×W×H |
2800×1580×1950mm |
|
Weight |
1400 Kg |
